Pancegahan pikeun pamasangan sareng mesin uji jenis hook shot shot blasting machineï¼ˆä¸ € ï¼ ‰

Themesin tipe shot shot blastingumumna ngagaduhan penampilan anu langkung ageung, sareng prosés pamasanganna langkung rumit tibatan alat-alat alit. Instalasi sareng mesin uji anu leres mangrupikeun konci pikeun mastikeun operasi normal pikeun peralatan engké. Dina kasus operasi awal anu henteu terampil, pangguna diperyogikeun pikeun leres-leres nuturkeun instruksi ti personalia anu aya hubunganana atanapi ningali pitunjukna. Operasi anu teu diidinan tiasa sacara gampang nyababkeun karusakan anu teu tiasa dibalikkeun kamesin shot shot blasting. Theshot blasting machine manufacturer has sorted out the precautions for installation and test machine to share with you. I hope it will be helpful to users who use the device for the first time.
1. Installation. Themesin tipe shot shot blasting is installed and debugged in the production plant and disassembled into several parts before being transported to the user site for installation. Although there is no pit, the foundation must be firm, the anchor bolt holes must be standardized, and the chamber body must be adjusted. After the second irrigation, the anchor bolt nuts can be tightened after solidification. After the chamber body is fixed, the various parts can be installed. Theprecautions for the installation and debugging of the relevant components are introduced below.
1. makéna alat blasting:
Theshot blasting device has been installed on the chamber body before leaving the factory. Please pay attention to the problems to be debugged before use. Check whether the fixed positions of the blade, the pill wheel, the directional sleeve, and the guard plate are accurate and firm, and check whether the direction of rotation is correct after power on. Then adjust the position of the directional sleeve opening. Theoretically, the angle between the front edge of the directional opening and the front edge of the blade throwing position is about 900. After fixing the position of the directional sleeve, the position of the projectile belt can be detected by hanging Place a steel plate or wooden board on the position of the workpiece facing the exit of the shot blasting machine, start the shot blasting machine, put a small amount (2-5kg) of projectiles into the blasting tube, and then stop, check whether the hit position on the steel plate is suitable for the needs, such as Close the window of the bias-adjustable directional sleeve downwards, and vice versa, until it fits, and note the position of the directional sleeve opening as a basis for future replacement of the directional sleeve.
2. kerekan sareng conveyor sekrup:
Mimiti ngalaksanakeun tés henteu-beban pikeun mariksa naha LIPI angkat sareng agul-agul spiral ngalir dina arah anu leres, teras kenceng sabuk tina kerekan kana tingkat sedeng tegangan pikeun ngahindarkeun panyimpangan, teras ngalaksanakeun uji beban pikeun mariksa operasi sareng kapasitas panganteur, naha aya anéh Noise sareng geter, parios sareng cabut halangan.
3. Pél-pasir pamisah:
Mimiti parios naha gerak ram fléksibel, teras parios posisi anu saé tina pelat pamisah, teras nalika kerekan dimuat sareng debugging, aya aliran masuk nembak baja anu teras-terasan, sareng parios naha nembak baja ngalir sareng murag nalika peucang dikaluarkeun